The PARIS Forums


Home » The PARIS Forums » PARIS: Main » new to Paris
Re: new to Paris [message #101522 is a reply to message #101521] Tue, 09 December 2008 09:46 Go to previous messageGo to previous message
Mike Audet is currently offline  Mike Audet
Messages: 294
Registered: December 2008
Senior Member
Hi John,

Welcome aboard!

The 8 pin mini din connection is to use an IF2 (2 in 2 out module) with the
card. If you're using a 442 or an MEC, you'd plug the IF 2 into the 442
or MEC for additional inputs and outputs. You shouldn't need a cable. It's
attached to the IF2.

Installation under XP still requires some heardles, but it works. Follow
the instructions at:

http://www.parisfaqs.com/parisonxp.html

I have just released a new driver that you will need if you want to run PARIS
on a multi-cpu or hyperthreded PC. The drivers along with some great plugins
are available at:

www.ensoniq.ca.

All the best,

Mike


"John Minnella" <minnella@lfe.arizona.edu> wrote:
>
>I picked up a Paris with a MEC, 442, computer and Control 16. In the Paris
>software one has to hold down the left mouse button or the menus go away.
>We are short the 8 pin mini din cable which should be here Friday. Is there
>some special mouse required or is this a wrinkle in this particular system?
>
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Survey For You
Next Topic: My biggest success...
Goto Forum:
  


Current Time: Fri May 31 22:44:04 PDT 2024

Total time taken to generate the page: 0.00987 seconds