The PARIS Forums: PARIS: Projects » Standalone ESP2 development board?

Home » The PARIS Forums » PARIS: Projects » Standalone ESP2 development board?

Show: Today's Messages :: Polls :: Message Navigator

Re: Standalone ESP2 development board? [message #108114 is a reply to message #108113]

Fri, 14 February 2014 12:48

Doug Wellington

Messages: 251
Registered: June 2005
Location: Tucson, AZ, USA

Senior Member

I haven't actually worked with any RME stuff as of yet.

If I get a chance this weekend, I'll look at the various bus specifications to see if I can leverage one of the designs from the Papilio, the Mojo, or the BBB. The Ensoniq stuff uses the I²S protocol, but most of the recent stuff I've used is SPI-based. Worst case, I'll find some kind of converter or use a CPLD or small FPGA to make one...

http://www.parisfaqs.com

Report message to a moderator

[Message index]

		Standalone ESP2 development board? By: Doug Wellington on Fri, 14 February 2014 10:33
		Re: Standalone ESP2 development board? By: kerryg on Fri, 14 February 2014 11:04
		Re: Standalone ESP2 development board? By: Doug Wellington on Fri, 14 February 2014 12:48
		Re: Standalone ESP2 development board? By: kerryg on Fri, 14 February 2014 13:04
		Re: Standalone ESP2 development board? By: Doug Wellington on Fri, 14 February 2014 14:09
		Re: Standalone ESP2 development board? By: excelav on Thu, 20 February 2014 22:24

Previous Topic:	Reverse engineering the EDS card.
Next Topic:	software updates

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun May 12 12:58:39 PDT 2024

Total time taken to generate the page: 0.01216 seconds