Re: Selling Paris gear [message #108919 is a reply to message #108918] |
Sat, 19 September 2015 07:10 |
danielcornelius
Messages: 171 Registered: May 2012
|
Senior Member |
|
|
@Will
not the whole Paris Stuff, but i have buyed a lot of Stuff in the past.Some Stuff i have lease to friend and get it back now.
I have "jumped" to Universal Audio Apollo now.
So my Setup today is :
Apollo Quad
1x Paris MEC /2 Adat/ 8 input / 8 output
RME 9652
RME 9632
Universal Audio UAD2 Quad
UA Twin Finity 4710d
UA Compressor 1176ae
to go into DAW. With Paris i have 32 I/O. Thats enough, i have decided !
In the Past were 16 I/O Adats in my DAW blocked by E6400 Sampler. I will rout them over RME 5652 into my System.
I have used two 4710d going into second MEC.
The Third MEC was fillend by other Romplers (Proteus 1000 & 2x2000, An1x,X3,ChaosPad)and so on.
Apollo is real good. The special is, you can use your plugins in realtime !
Have a nice Weekend everyone.
@Kerry
THX to Kerry...for "You don't necessarily need a second MEC, you can run a two card system with a single MEC - if you just have one, the audio from both EDS cards is pre-mixed and flows through it. ", thats exactly what i like to say !
Have a nice Weekend too !
----------------------------
- Asio Driver Cubase 5LE,Cubase 12
- Asus Z97-C, LGA 1150
- Intel i5 2320
- 32GB RAM
- 4x Seagate Barracuda 750GB
- Win10 64 bit
[Updated on: Sat, 19 September 2015 07:17] Report message to a moderator
|
|
|