The PARIS Forums: PARIS: Main » issues with headphone mix setup

Home » The PARIS Forums » PARIS: Main » issues with headphone mix setup (headphone mix)

Show: Today's Messages :: Polls :: Message Navigator

issues with headphone mix setup [message #105214]

Mon, 19 April 2010 06:16

Oui_Oui

Messages: 51
Registered: December 2009

Member

I have an mec , 8in card, adat card.. Followed path that was suggested in paris wiki .. Still having issues with seperating headphone left and right to furman hds... I found the only way I get the aux send to work is to put an effect on it (compressor 1:1) . Is that true?? The monitor out L/R on the back of the mec is what I'm sending to headphone amp... should be two seperate channels .. I'm hearing things on both channels not seperated... Any ideas...???????? Tried pushing mono on sends ... Compressor is a mono effect I think.... thx

Report message to a moderator

Re: issues with headphone mix setup [message #105215 is a reply to message #105214]

Mon, 19 April 2010 07:18

drfrankencopter

Messages: 137
Registered: July 2009

Senior Member

Not sure what the wiki says, but if you want to headphone monitor using the aux sends for 2 independent, mono mixes, then do the following:

1) Make your physical connections (e.g. MEC out 3&4 to Furman In 1 & 2)
2) In the Paris patch bay, connect MEC output 3 to Aux 1, and output 4 to Aux 2
3) In the mixer window select 'External' for the FX on Aux 1 & 2 (note that this has to be on the same Submix as your mec is attached to). While you're here, select mono on the sends
4) Enable the aux sends on the channels you want to monitor...
5) Now you should have independant mono auxes

Cheers

Kris

Report message to a moderator

Previous Topic:	Am I deaf or what?
Next Topic:	Paris Converters?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Nov 28 09:47:24 PST 2024

Total time taken to generate the page: 0.00765 seconds