The PARIS Forums


Home » The PARIS Forums » PARIS: Main » Curious about the add-on Paris reverbs
Curious about the add-on Paris reverbs [message #109438] Fri, 19 January 2018 16:50 Go to next message
RGPJ is currently offline  RGPJ   UNITED STATES
Messages: 15
Registered: October 2017
Junior Member
Are they of much higher quality than the stock ones? The stock ones seem rather strange...a bit clangy. The plate is okay, but the room seems pretty awful. I don't really like digital reverb in general though.

Anyone have any comparisons between the stock ones and the add-ons?

(I realize the add-ons are, together, only $145, but if they aren't for me, I'd just as soon put that to some other hardware verb...any recommendations on that, btw, that's not too pricey?)

Thanks!
Re: Curious about the add-on Paris reverbs [message #109440 is a reply to message #109438] Fri, 19 January 2018 17:28 Go to previous messageGo to next message
kerryg is currently offline  kerryg   
Messages: 1529
Registered: February 2009
Senior Member
Administrator
The reverbs by Mike are in fact actually "hardware reverbs". Since the DP family of Ensoniq FX processors used the same chips as the EDS1000, Mike was able to port their algorithms to EDS plugins so you're literally getting some of the prime reverbs from those hardware units but with the benefits of them being inside your project (no going through two AD/DA stages using whatever converters the DP series had, plus presets saved inside the project so you don't have to recall them to touch up a mix). There's some lovely stuff in there - if I recall, some of the original EDS plugins were "lite" versions to reduce demands on the EDS card and Mike's restored the "full fat" versions of some of them.

"... being bitter is like swallowing poison and waiting for the other guy to die..." - anon
Re: Curious about the add-on Paris reverbs [message #109442 is a reply to message #109438] Sat, 20 January 2018 03:48 Go to previous messageGo to next message
Kim W. is currently offline  Kim W.   AUSTRALIA
Messages: 189
Registered: January 2010
Location: Australia
Senior Member
Mike's Reverbs are fantastic! Do yourself a favour and get the Drum Plate, at the very least. I also have the vocal plate, which I haven't tested thoroughly, as my mobo has given up the ghost, and I'm working on solutions as we speak. (Nothing to do with the plugin...) I would also recommend the class A amp. It does a fantastic job of providing a real time Amp simulation during tracking with a D.I. signal. (A little tweaking is required).
Re: Curious about the add-on Paris reverbs [message #109445 is a reply to message #109438] Sat, 20 January 2018 22:54 Go to previous messageGo to next message
Will The Weirdo is currently offline  Will The Weirdo   
Messages: 190
Registered: December 2009
Location: On The Lake
Senior Member
Do Mike's verbs come with any presets?
Re: Curious about the add-on Paris reverbs [message #109448 is a reply to message #109445] Sun, 21 January 2018 05:21 Go to previous messageGo to next message
Kim W. is currently offline  Kim W.   AUSTRALIA
Messages: 189
Registered: January 2010
Location: Australia
Senior Member
I don't think so, but all parameters are easily adjustable and self explanatory. (reverb time, predelay, hi-pass, lo-pass etc. I never bothered to look, to be honest. It was easy to dial up what I wanted.
Cheers,
Kim.
Re: Curious about the add-on Paris reverbs [message #109449 is a reply to message #109438] Sun, 21 January 2018 07:45 Go to previous messageGo to next message
Will The Weirdo is currently offline  Will The Weirdo   
Messages: 190
Registered: December 2009
Location: On The Lake
Senior Member
I know I'm asking rookie questions Kim, but it's been at least 15 years since I used a PARIS verb. I was using a Kurzewil KSP8 for my last 5 full time PARIS years before I moved to Atlanta. These days I'm deep into Nebula with a huge library and I beta test for AA. I'll be premixing with Nebula before mixing in PARIS so I just don't know how much I'll use any PARIS verbs.

Jumping back into PARIS has me rethinking everything but I love every mix I do in PARIS over what I do in other DAW's. The mid buildup is magic to me once you know how to use it as an advantage, and don't get me started about driving into the EQ trim for saturation! I have to fight in every other DAW for any kind of mid magic as there is always so much top end extension.

So to me PARIS is kinda like a vintage U47 or U67 in sound and these other new DAW's are like a modern sounding Sony C800G or Brauner VM-1. PARIS is thick, smooth, with a forgiving sonic character while other DAW's are surgical, precise and unforgivably sterile.

To each their own but I keep coming back to PARIS for a reason.
Re: Curious about the add-on Paris reverbs [message #109450 is a reply to message #109449] Mon, 22 January 2018 10:43 Go to previous messageGo to next message
Kim W. is currently offline  Kim W.   AUSTRALIA
Messages: 189
Registered: January 2010
Location: Australia
Senior Member
Me too.
I tend to build mixes which end up too hot, over 4 EDS cards. (some DX/VST plugins need taming, by reducing their output). But the EDS plugins are quite forgiving. When using EDS send fx, I always reduce the send levels aprox -10 db, and make up on the returns by boosting by 10 db.
Then, if the mix is too hot, (too many red lights in the global section, I reduce each of the 4 EDS faders by the same amount. Some "overs", are OK. as Paris never actually clips, if the native plugins are sorted. (Keep Global Master at default 0db)

As a precaution, Every time I start a session, my default projects have the channel strip gains set at +3db. This gives a bit of a safety net in case things get over enthusiastic during recording. (I like to keep the meters showing high, and gives me "peace of mind" if the drummer hits harder than during pre recording level checks. (I ALWAYS have the meters set pre-fade, not post-fade. It's a lot easier to see what's going on, gain structure-wise).

I realise I've strayed a bit from the original post, but I do recommend mike's plugins. There are also a few "freebies" to be had.
One I use often is a plugin called "Pseudo". It can give a nice slight stereo spread to something like a vocal track. (I think this was released years ago before Mike's work, but well worth the price of $0. It is a send only plugin, and very low on resources. Can give a bit of a "psychedelic" feel to the vocal or any mono signal, especially through headphones).
Cheers,
Kim.

P.S. There is a little known bug in V3 which applies only when you re-load a project for further work. Some of the send returns can revert to being mono, and appear only in one channel. (This has occurred since the release of V3, and I think applies to any Stereo send FX). As a matter of course, every time I resume a mix when re-opening the project I toggle the stereo/mono switch on the return strips on all submixes.. This corrects the problem. To see what I mean, reload a project, and solo the returns before toggling.


[Updated on: Mon, 22 January 2018 11:27]

Report message to a moderator

Re: Curious about the add-on Paris reverbs [message #109451 is a reply to message #109442] Mon, 22 January 2018 15:24 Go to previous messageGo to next message
RGPJ is currently offline  RGPJ   UNITED STATES
Messages: 15
Registered: October 2017
Junior Member
Kim W. wrote on Sat, 20 January 2018 03:48
Mike's Reverbs are fantastic! Do yourself a favour and get the Drum Plate, at the very least. I also have the vocal plate, which I haven't tested thoroughly, as my mobo has given up the ghost, and I'm working on solutions as we speak. (Nothing to do with the plugin...) I would also recommend the class A amp. It does a fantastic job of providing a real time Amp simulation during tracking with a D.I. signal. (A little tweaking is required).


Maybe I will try one out. I was thinking of getting the room verb (for drums) because the stock one is so odd. But is the drum plate a lot better?

Thanks everyone for the replies!
Re: Curious about the add-on Paris reverbs [message #109452 is a reply to message #109449] Mon, 22 January 2018 15:30 Go to previous messageGo to next message
RGPJ is currently offline  RGPJ   UNITED STATES
Messages: 15
Registered: October 2017
Junior Member
Will The Weirdo wrote on Sun, 21 January 2018 07:45
I know I'm asking rookie questions Kim, but it's been at least 15 years since I used a PARIS verb. I was using a Kurzewil KSP8 for my last 5 full time PARIS years before I moved to Atlanta. These days I'm deep into Nebula with a huge library and I beta test for AA. I'll be premixing with Nebula before mixing in PARIS so I just don't know how much I'll use any PARIS verbs.



So the Nebula reverbs are as good as the Kurzweil?

Re: Curious about the add-on Paris reverbs [message #109453 is a reply to message #109452] Mon, 22 January 2018 16:52 Go to previous message
Will The Weirdo is currently offline  Will The Weirdo   
Messages: 190
Registered: December 2009
Location: On The Lake
Senior Member
The Nebula verbs are special and IMHO the best plugin verbs, but I believe hardware verbs still are superior to plugins.

[Updated on: Mon, 22 January 2018 16:55]

Report message to a moderator

Previous Topic: Asio driver
Next Topic: Hello from a New Paris User
Goto Forum:
  


Current Time: Tue Dec 17 11:06:32 PST 2024

Total time taken to generate the page: 0.00895 seconds