Home » The PARIS Forums » PARIS: Main » Curious about the add-on Paris reverbs
|
|
|
|
|
|
Re: Curious about the add-on Paris reverbs [message #109450 is a reply to message #109449] |
Mon, 22 January 2018 10:43 |
Kim W.
Messages: 189 Registered: January 2010 Location: Australia
|
Senior Member |
|
|
Me too.
I tend to build mixes which end up too hot, over 4 EDS cards. (some DX/VST plugins need taming, by reducing their output). But the EDS plugins are quite forgiving. When using EDS send fx, I always reduce the send levels aprox -10 db, and make up on the returns by boosting by 10 db.
Then, if the mix is too hot, (too many red lights in the global section, I reduce each of the 4 EDS faders by the same amount. Some "overs", are OK. as Paris never actually clips, if the native plugins are sorted. (Keep Global Master at default 0db)
As a precaution, Every time I start a session, my default projects have the channel strip gains set at +3db. This gives a bit of a safety net in case things get over enthusiastic during recording. (I like to keep the meters showing high, and gives me "peace of mind" if the drummer hits harder than during pre recording level checks. (I ALWAYS have the meters set pre-fade, not post-fade. It's a lot easier to see what's going on, gain structure-wise).
I realise I've strayed a bit from the original post, but I do recommend mike's plugins. There are also a few "freebies" to be had.
One I use often is a plugin called "Pseudo". It can give a nice slight stereo spread to something like a vocal track. (I think this was released years ago before Mike's work, but well worth the price of $0. It is a send only plugin, and very low on resources. Can give a bit of a "psychedelic" feel to the vocal or any mono signal, especially through headphones).
Cheers,
Kim.
P.S. There is a little known bug in V3 which applies only when you re-load a project for further work. Some of the send returns can revert to being mono, and appear only in one channel. (This has occurred since the release of V3, and I think applies to any Stereo send FX). As a matter of course, every time I resume a mix when re-opening the project I toggle the stereo/mono switch on the return strips on all submixes.. This corrects the problem. To see what I mean, reload a project, and solo the returns before toggling.
[Updated on: Mon, 22 January 2018 11:27] Report message to a moderator
|
|
|
|
|
|
Goto Forum:
Current Time: Wed Dec 18 01:26:15 PST 2024
Total time taken to generate the page: 0.01431 seconds
|