The PARIS Forums


Home » The PARIS Forums » PARIS: Main » Slaving Separate comp using RME via ADAT SYNC. (problem).
Slaving Separate comp using RME via ADAT SYNC. (problem). [message #109099] Thu, 03 March 2016 21:44 Go to previous message
Kim W. is currently offline  Kim W.   AUSTRALIA
Messages: 189
Registered: January 2010
Location: Australia
Senior Member
Hi all.
I remember a while ago people were running Cubase on a separate machine, using ADAT sync to keep the two boxes locked.
Up until recently, I have been using a Frontier Dakota card on a WINXP machine with no problems.
I have built a newer PC to run Cubase, under WIN7 64bit.
I had problems getting the Dakota running on the new machine.
I purchased an RME 9652 quite cheaply, and the drivers installed fine. Everything is working, except that When Paris is stopped, the outgoing sync causes Cubase to hover around the stop point, but play and stop keep toggling very rapidly. If there is a midi note at the point where Cubase stopped, it keeps endlessly triggering that note continuously, and very rapidly.
This is my first experience with RME stuff.
ave I missed something? Is there a hidden command or config setting that I have overlooked?
Any insight would be appreciated.
Cheers,
Kim
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: New Windows 10 Warning
Next Topic: Any PARIS Mac OS9 users here nowadays?
Goto Forum:
  


Current Time: Wed Dec 18 19:26:30 PST 2024

Total time taken to generate the page: 0.01504 seconds