The PARIS Forums: PARIS: Main » Anyone know how to config Paris to use converters into Pro Tools

Home » The PARIS Forums » PARIS: Main » Anyone know how to config Paris to use converters into Pro Tools (Paris A/D converters as stand alone into other DAWs)

Show: Today's Messages :: Polls :: Message Navigator

Anyone know how to config Paris to use converters into Pro Tools [message #103962]

Fri, 14 August 2009 17:14

Johnny Reno

Messages: 12
Registered: May 2007

Junior Member

I am trying to use Paris A/D converters using Paris ADAT card optical into Pro Tools 002 for recording. I have a project that needs to go into Pro Tools, but I would like to use Paris converters. Anyone have any luck with this. Is it even possible?
If so how do you config it. Thanks much Johnny.

Report message to a moderator

Re: Anyone know how to config Paris to use converters into Pro Tools [message #103987 is a reply to message #103962]

Thu, 20 August 2009 00:36

Ted Gerber

Messages: 705
Registered: January 2009

Senior Member

No where near my system right now, but I _think_ if you set the "monitor" mode in the Project Window to "live Mix" or something like that (as opposed to always Monitor Input, or Monitor While Recording) and then in the PatchBay route your audio in straight out through the ADAT outs, as if you were using the ADATs for cue mix sends : ADI In1 - ADAT out1 etc it should work.

Using ADAT sync is another matter, if you're doing multiple takes; punch ins and so oo, then you need to just keep the time line running in PT and cut and paste later, or learn about the ADAT sync requirements for the PARIS ADAT card. Kerry G just posted a link to the manual in another thread...

Ted

Report message to a moderator

Previous Topic:	IMPORTANT NOTICE: THE OLD NG IS *NOT* COMING BACK
Next Topic:	Any Aussies still out there?

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Jun 12 00:09:34 PDT 2025

Total time taken to generate the page: 0.03167 seconds