Home » The PARIS Forums » PARIS: Main » New Build for Paris
| New Build for Paris [message #102515] |
Sun, 15 February 2009 16:26  |
Tom Bruhl
Messages: 1368
Registered: June 2007
|
Senior Member |
|
|
Since all is going so well finally I thought it would be
good to show what's possible with Paris and a quadcore.
I have 4 EDS, 2 Mecs, 1 UAD-2, 1 UAD-1 installed with 4GB Ram
with a Q9450 Yorkfield 2.66 quadcore.
I'm using a 29 track mix with plenty of edits, 15 or so Paris plugs
scattered about. Maybe 2 Autotunes, 5 UAD whatevers, 4 Voxengo
whatevers and Faderworks across all 64 tracks.
Then I decided to push it.
I put 29 Waves Ren comps across all tracks as the transport
was playing. No glitches (plenty of edits too) but with no GUIs
open. I was impressed since the CPU didn't exceed 10%.
I installed a few Waves SSL Channel Strips with no glitches,
transport still running in loop mode. If anyone knows that plug,
it's gui is very hard on the graphics card as well as being a little
CPU intensive. I got brave and added 25 with only a glitch or two.
GUIs closed. Now we're talking 60+ native plugs and the CPU
is peaking around 15-20%. Smooth audio although mix got a little
goofy sounding!
Then I got really brave... I started opening the SSL GUIs making
sure to leave the meters showing on each one. I got 6 going with the
CPU up between 35 + 45% . This was unheard of on my old box.
Transport would stop after 2 as I recall. I added the seventh GUI when
I got the Paris Assertion Error we all know. Yes it crashed and I couldn't
find the save I tried to make either.
Bottom line is the CPU never reached beyond 50% and the internal latency I
have been keeping to a minimum never exceeded 208us! That's incredible
from my experience.
After I backup it'll be time for the Creamware card, Cubase 4.5,
Midi 8x8 patchbay.
New UAD latency with ver 5.2 is:
8256 samples most plugs including Neve 88R
Helios and Pultec 8287 samples
This is about half as long from the old revs. The install is also
easier for us because the EX1 and Fairchild load correctly
first time out. Just wrap with FxPansion 3.3 and all is well.
Thanks again to Mike Audet for being so helpful when
I was ready to throw in the towel. His drivers are making
this all possible. Buy 'em. Good for multi ADATs, ADAT sync
and Hyperthreading comps too.
Tom
|
|
|
|
Current Time: Fri Nov 22 19:20:49 PST 2024
Total time taken to generate the page: 0.01158 seconds
|
The PARIS Forums
Search
Help
Members
Register
Login
Home
