The PARIS Forums


Home » The PARIS Forums » PARIS: Main » Hey guys.........here's something else not to do!!!
Hey guys.........here's something else not to do!!! [message #68877] Fri, 02 June 2006 16:33 Go to previous message
Deej [1] is currently offline  Deej [1]   UNITED STATES
Messages: 2149
Registered: January 2006
Senior Member
Don't run a 15' WC cable from your master clock module to two distro
modules, then use another short WC cable to link the distro modules together
and then run other WC cables of differing lengths to 3 x RME interfaces and
3 x MECs while also running ADAT sync cables from 3 x Paris ADAT modules to
the ADAT sync inputs of the 3 x RME cards while the digital I/O of the RME
cards, the Paris modules, all of your external spdif gear and ADAT gear is
all patched into three different M-Audio Digipatch units which are daisy
chained to each other using spdif cables in an attempt to allow simultaneous
clocking of everythiong from two different sources derived from the same
master clock while cross patching all of the digital I/O between various
lightpipe, coax and optical spdif devices through these digital patchbays
that, BTW, don't reclock the incoming/outgoing signal.

I know a bunch of you guys were getting ready to do this , but just say no.

(I swear there was a valid reason for trying this.........really there was)

;oD

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Paris tip of the day. DON'Ts
Next Topic: Clear Peak lights with macro express
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Mon May 05 00:16:16 PDT 2025

Total time taken to generate the page: 0.01539 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software