The PARIS Forums: PARIS: Main » Digitally patching hardware during tracking, extra conversion stage?

Home » The PARIS Forums » PARIS: Main » Digitally patching hardware during tracking, extra conversion stage?

Show: Today's Messages :: Polls :: Message Navigator

Digitally patching hardware during tracking, extra conversion stage? [message #108661]

Thu, 09 April 2015 16:41

n0samples

Messages: 50
Registered: February 2015

Member

Lets say I have a mic pre connected to the MEC.
Let's also say I have a compressor whose I/O is also connected to the mec.

If I'm recording a vocal and want to send it to the hardware compressor, is the MEC rerouting the mic output signal straight to the compressor , or converting it digitally then converting it again to send it to the input and then converting the output to the computer?

[Updated on: Thu, 09 April 2015 16:47]

Report message to a moderator

Re: Digitally patching hardware during tracking, extra conversion stage? [message #108662 is a reply to message #108661]

Thu, 09 April 2015 20:45

Kim W.

Messages: 189
Registered: January 2010
Location: Australia

Senior Member

If you use the inserts, then of course the signal is converted to analog, and then back to digital. Paris will not record the compressed signal, only the direct output of the preamp. (Unless of course you route the compressed signal into a new channel via another mec input, which defeats the purpose).
If you want to track WITH compression, then feed the preamp signal into compressor, then into a MEC input.
Cheers,
Kim

Report message to a moderator

Previous Topic:	Still waiting for SWD PCI expansion
Next Topic:	Rcvd PCI/PCIe hosts and 1035 expansion

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Dec 21 06:58:42 PST 2024

Total time taken to generate the page: 0.00650 seconds