The PARIS Forums: PARIS: Main » Help

Home » The PARIS Forums » PARIS: Main » Help - MEC not showing up

Show: Today's Messages :: Polls :: Message Navigator

Help - MEC not showing up [message #90840]

Sun, 30 September 2007 20:09

Ted Gerber

Messages: 705
Registered: January 2009

Senior Member

I fried my EDS card last week through carelessness, and Geoff from just outside
Chicago was kind enough to contact me to the end that I've purchased a system
from him that will arrive later this week.

Problem is, I'm scheduled for a session tomorrow. I have just returned with
a
loaner EDS from a friend, dropped it in the Mac and fired up the system.
No MEC
shows up. I disconnected and hooked it up to a spare 442, no 442. Both I/O
boxes
start their usual routine when I launch Paris, but both seem unable to finish.

The from TheSoniq, says that it's common for the digital board in the MEC
to get
fried when the card shorts, but it seems unlikely to me that the 442 is gone
too.

My question is: What else would cause a MEC (or 442) to not be seen at Paris
start
up?

Any help appreciated

Ted

Report message to a moderator

Previous Topic:	funny that
Next Topic:	RME D/A converters

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 17 11:38:45 PDT 2025

Total time taken to generate the page: 0.01132 seconds