The PARIS Forums


Home » The PARIS Forums » PARIS: Main » Paris ADAT sync to Pulsar II for sample accurate lock.
Paris ADAT sync to Pulsar II for sample accurate lock. [message #105591] Wed, 01 September 2010 14:40 Go to previous message
mani1147 is currently offline  mani1147   CANADA
Messages: 130
Registered: May 2009
Location: NB Canada
Senior Member
Hi everyone, here is a copy of what I posted over on the PlanetZ Pulsar forum:
------------------------------------
Hi everyone, thanks for looking, here is my setup:

Paris system / proprietary HW with ADAT card (master)
Cubase SX3 using PULSAR II (slave)
Both apps installed in i7 PC , XP pro SP3

Have Cubase set to "ASIO Position Protocol"
Lightpipe send/return connected to Paris and Pulsar
ADAT 9pin sync cable connected to Paris and Pulsar

Problem:
When I hit play in Paris app, Cubase playback starts but after 2-3 seconds jumps forward a little then 3-4 seconds later jumps back a bit and eventually seems to settle in place after 20 secs or so but not consistent sample accurate by a long shot.
I have tried tweeking the sync setings in Cubase but still have prob.

Any help I could get would be greatly appreciated.

Thanks
Roby
---------------------------------

Is anyone here using or have used PulsarII sync to Paris reliably, did you experience this funky behavior?
I am about 24hours away from picking up an RME 9654, this should work rite?

Thanks
Rob
 
Read Message
Read Message
Read Message
Read Message
Previous Topic: Cable from EDS to MEC- SCSI?
Next Topic: Drumagog 4
Goto Forum:
  


Current Time: Mon Dec 23 05:23:45 PST 2024

Total time taken to generate the page: 0.00640 seconds