The PARIS Forums


Home » The PARIS Forums » PARIS: Main » ADAT sync problems on HDSP9652 and Cubase 5.1.0
ADAT sync problems on HDSP9652 and Cubase 5.1.0 [message #104303] Sat, 07 November 2009 14:05 Go to next message
auberg is currently offline  auberg   NORWAY
Messages: 4
Registered: March 2007
Junior Member

Hi,

I am having problems with receiving start and stop signals over ADAT sync. running Cubase 5 as slave using the HDSP5692 card. The transport immediately starts running, and never stops even if the stop button is hit on the master system. Sync information is however detected if the jog wheel on the master system is moved, and the transport locator is correctly synced in the slave system. The start and stop signals are however never received, so the transport runs forever in the slave system.

This problem only appears in Cubase 5, Cubase SX 3 is running fine.

Any one knows a solution for this?


The setup:

Motherboard: P4s800-mx
CPU: Intel 2.6 GHz
RAM: 2Gb

OS: Windows XP SP2

HDSP9652: Fut 108
Driver: wdm 3.0.82
ADAT 1: In sync
ADAT sync: In sync


Cubase 5.1.0: Slave
PARIS 3.0: Master


BR

Arne-J. Auberg


Re: ADAT sync problems on HDSP9652 and Cubase 5.1.0 [message #104307 is a reply to message #104303] Mon, 09 November 2009 04:28 Go to previous message
dnafe is currently offline  dnafe   CANADA
Messages: 390
Registered: February 2009
Senior Member
Really dumb Q

Are you using ASIO positioning protocol (or some damn name like that) as your sync.

I found that I could not get things to sync properly until I had that set up correctly...might have been just my system that required this but I thought I'd throw that out as a possibility

Previous Topic: otari raddar II to paris
Next Topic: Will Paris work on windows7
Goto Forum:
  


Current Time: Wed Dec 25 01:36:36 PST 2024

Total time taken to generate the page: 0.00667 seconds