Home » The PARIS Forums » PARIS: Main » Big Ben and DAC1
Big Ben and DAC1 [message #87946] |
Wed, 11 July 2007 11:50 |
Wayne Carson
Messages: 86 Registered: June 2007
|
Member |
|
|
Hi all,
It's been a week since I hooked up the benchmark and clock to my simple
1-MEC w/two 8-in, 2-EDS, 1-C16 system. I used 3' apogee cables on both and
one 75 ohm term on the MEC s/pdif out. I did not use a bnc "T".
It made a wonderful difference. I set the BB clock to internal at 44.1k and
used the bnc out to the MEC. I set Paris to word clock. That's it. It
locks at 44.1. I think I can even hear jitter on previously recorded stuff,
specifically on vocals when solo'ed, but then again it could be the coffee!
I've run 8 completely different song mixes that I am working on and it is so
much easier to find and correct things and so far appears to translate very
similar to my simple home stereo system, bedroom Bose/CD wave radio and '04
Honda Accord car sound system. And that's what it's all about for me. This
should make for a whole lot less trial and error mixing. My '06 Tundra
truck sound system is not even close, but that's another issue.
In my studio, I individually A/B'd the clock and the DAC against the Paris
L/R monitor out and internal clock. In each case the clock and/or the DAC
cleaned up the low/mid mushiness, allowed the kick to be heard with the bass
and not a boom but a punch, spaced out the depth, ambiance and stereo field
and overall gave clarity to the mix. Paris EDS efx's are more
distinguishable now.
Previously I used the Paris L/R monitor out to my 1604vlz (ch 15-16) trim
off, eq flat, level at unity and the main's out to my Alesis RA-100 (yah, I
know it's not so good, but I thought I was getting a decent flat ref amp
when I bought it back in '96.) to yama's NS-10's and a sub under my desk for
fill and to curl my toes.
I was very suprised to find out how bad the Mackie colored the sound. A
very noticable harshness around 1-2khz and possibly higher, lack of warmth
between 100-300hz and just an overall sound like crowded, cramped, busy and
flat tonality. Tweaking the 3 eq's helps but only removed about half the
problem. This is compared to the MEC digita s/pdif out to the DAC1 and it's
XLR outs to the RA-100 to the NS-10s. This sound was warm and round, almost
surround. It put a smile on my face.
I'm a happy camper. Special thanks to Dave, Kim, DJ, Miguel, Jeff and Neil.
I guess my next purchase will be an appropriate reference pwr amp.
Thanks,
Wayne
Paris since '97
|
|
|
|
|
Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: rich on Thu, 12 July 2007 11:30
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: Neil on Fri, 13 July 2007 19:05
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: Nil on Sat, 14 July 2007 15:38
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: Neil on Sun, 15 July 2007 08:26
|
|
|
Re: Big Ben and DAC1
By: DJ on Sun, 15 July 2007 09:34
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: DJ on Sun, 15 July 2007 23:19
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: TCB on Fri, 13 July 2007 07:45
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: Bill L on Wed, 11 July 2007 19:41
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: Bill L on Fri, 13 July 2007 05:08
|
|
|
Re: Big Ben and DAC1
By: DJ on Fri, 13 July 2007 05:52
|
|
|
Re: Big Ben and DAC1
|
|
|
Re: Big Ben and DAC1
By: DJ on Wed, 11 July 2007 20:59
|
Goto Forum:
Current Time: Fri Nov 29 03:16:40 PST 2024
Total time taken to generate the page: 0.01268 seconds
|