The PARIS Forums: PARIS: Main » MEC and eds cards under water

Home » The PARIS Forums » PARIS: Main » MEC and eds cards under water

Show: Today's Messages :: Polls :: Message Navigator

MEC and eds cards under water [message #91638]

Fri, 19 October 2007 06:48

Steve L
Messages: 1
Registered: October 2007

Junior Member

My studio in Stamford CT was under five feet of water. Does my paris hardware
stand a chance ? I have a mec with two 8in, one 8 out, a c16, and two eds
cards.

Thanks,

Steve L.

Report message to a moderator

Re: MEC and eds cards under water [message #91639 is a reply to message #91638]

Fri, 19 October 2007 07:07

TCB
Messages: 1261
Registered: July 2007

Senior Member

It probably does. Computer gear (save hard drives) can usually go through
a washer and come out OK. The most important thing to do is let everything
dry COMPLETELY before turning it on. Take all of the external metal you can
off of the MEC so the boards can dry out. Pull the MEC cards (carefully)
so the contacts can dry out. Then lay everything out and point a fan at it
and let it blow for a day or two, turning everything over to be sure it's
dry. (I've used a blow dryer before but that can heat things up too much
if you're not careful). After that I'd try turning on the MEC only and seeing
if anything works. Then add one card at a time. You might get lucky, or you
might not. But if you start firing the stuff up when it's wet you're cooked.

TCB

"Steve L" <steve@shangk.com> wrote:
>
>My studio in Stamford CT was under five feet of water. Does my paris hardware
>stand a chance ? I have a mec with two 8in, one 8 out, a c16, and two eds
>cards.
>
>Thanks,
>
>Steve L.

Report message to a moderator

Re: MEC and eds cards under water [message #91654 is a reply to message #91639]

Fri, 19 October 2007 09:51

rick

Messages: 1976
Registered: February 2006

Senior Member

+1

On 20 Oct 2007 00:07:46 +1000, "TCB" <nobody@ishere.com> wrote:

>
>It probably does. Computer gear (save hard drives) can usually go through
>a washer and come out OK. The most important thing to do is let everything
>dry COMPLETELY before turning it on. Take all of the external metal you can
>off of the MEC so the boards can dry out. Pull the MEC cards (carefully)
>so the contacts can dry out. Then lay everything out and point a fan at it
>and let it blow for a day or two, turning everything over to be sure it's
>dry. (I've used a blow dryer before but that can heat things up too much
>if you're not careful). After that I'd try turning on the MEC only and seeing
>if anything works. Then add one card at a time. You might get lucky, or you
>might not. But if you start firing the stuff up when it's wet you're cooked.
>
>
>TCB
>
>"Steve L" <steve@shangk.com> wrote:
>>
>>My studio in Stamford CT was under five feet of water. Does my paris hardware
>>stand a chance ? I have a mec with two 8in, one 8 out, a c16, and two eds
>>cards.
>>
>>Thanks,
>>
>>Steve L.

Report message to a moderator

Previous Topic:	Stay away from S. Africa
Next Topic:	OT: Reaper sync request

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Jan 17 11:08:13 PST 2025

Total time taken to generate the page: 0.00818 seconds