The PARIS Forums: PARIS: Main » There is an ADAT bug under XP

Home » The PARIS Forums » PARIS: Main » There is an ADAT bug under XP

Show: Today's Messages :: Polls :: Message Navigator

There is an ADAT bug under XP [message #82856]

Sun, 08 April 2007 11:43

Dimitrios

Messages: 1056
Registered: August 2005

Senior Member

Hi,
I have concluded that there is finally a bug with adat cards.
Two of my adat cards (at least) can NOT fully close the cycle in-out-in as
a Paris insert on channels 5 & 6 ONLY.
Yes all other channels do this but 5 &^6 not.
I thought that I might have one adat card defected when I once detected this.
But now two of my adat cards do this and it is most unlikely to have been
damaged with this same strange behaviour !
You either get no signal on all 8 channels and not on 5 and 6 !
From what I detected is that you can have the ins working so sending from
Cubase to Paris all 8 work !, but it does not output from Paris adat 5 and
6 out...
Cheers,
Dimitrios

Report message to a moderator

Re: There is an ADAT bug under XP [message #82859 is a reply to message #82856]

Sun, 08 April 2007 17:38

Sandy Tipping

Messages: 54
Registered: June 2007

Member

Dimitrios,

I have this problem on some of my ADAT cards and I'm using WinME for my rig,
and I think I concluded it was a problem with the EDS card.
I have (1) loaded MEC (2 of everything). At one time, I used an ADAT loop
for realtime dumping of 8 tracks (8 insert sends to 8 new tracks, printed).
But 3 and 4 never worked. I swapped the EDS card that the MEC was connected
to (after swapping out the ADAT card twice) and things were healed.
Never bothered to do an exhaustive investigation - just chalked it up to
Paris weirdness.
Try a different EDS card in the same position on your mobo, connected to the
same MEC / ADAT combination. See if that does anything...

Sandy

"Dimitrios" <musurgio@NOSPAMotenet.gr> wrote in message
news:461937ea$1@linux...
>
> Hi,
> I have concluded that there is finally a bug with adat cards.
> Two of my adat cards (at least) can NOT fully close the cycle in-out-in as
> a Paris insert on channels 5 & 6 ONLY.
> Yes all other channels do this but 5 &^6 not.
> I thought that I might have one adat card defected when I once detected
> this.
> But now two of my adat cards do this and it is most unlikely to have been
> damaged with this same strange behaviour !
> You either get no signal on all 8 channels and not on 5 and 6 !
> From what I detected is that you can have the ins working so sending from
> Cubase to Paris all 8 work !, but it does not output from Paris adat 5 and
> 6 out...
> Cheers,
> Dimitrios

Report message to a moderator

Previous Topic:	red neck pick up lines
Next Topic:	Savage Macht 6

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 10 07:45:33 PDT 2025

Total time taken to generate the page: 0.01880 seconds