|
|
|
|
|
|
| Re: Adat BUG confirmed !!! can someone test too ? [message #83731 is a reply to message #83718] |
Thu, 26 April 2007 11:51  |
Sandy Tipping
Messages: 54
Registered: June 2007
|
Member |
|
|
Have you tried:
1 - Routing something OTHER than Insert Sends to these ADAT outputs (Main
Outs, Auxes etc)?
2 - Switching the EDS card / MEC assignment in the Master Mixer (ie, if the
troublesome ADAT outs are on MEC1 connected to Submix 1 playing off CardA,
does the same problem exist when you assign MEC1 / CardA to Submix 2 etc)
3 - Changing your EDS cards (basically, label them, pull them out, and put
them in the same PCI slots, in a different order - put a different EDS card
in the slot for the ADAT MEC).
I had a similar problem, but it was ADAT OUT 3 and 4 on MEC1 connected to
EDS Card A in a three card system on WinME. On this same MEC, there were a
total of (2) ADAT, (2) 8-input, (2) 8-output.
I had the same symptoms though - swapped ADAT cards and OUT 3 and 4 still
didn't wor, but the "bad" card suddenly worked in a different hole. The
"good" card displayed the same problem as the "bad" one.
I yanked and moved the EDS cards in my system and connected the MEC to a
different Card A and the problem went away with both the original ADAT and
the swapped ADAT.
I concluded it to be an EDS Insert problem on a specific EDS card - not an
OS thing. Something about the way the Insert Sends were handled on that EDS
card. Could be a loose connection on a board, a bad or dying chip etc. I
never bothered to check if you could route Auxes or Mains to the same
questionable outputs (and if I couldn't, it would be a bigger problem).
Sandy
"Dimitrios" <musurgio@otenet.gr> wrote in message news:463081a9$1@linux...
>
> So I have confirmed that at least under XP ,don't know if it is OS related
> bug, There is a bug where the track 5 and 6 of ADAT Paris OUT do NOT work.
> Out of four adat cards I have the three confirm this !
> The only case the fourth works is inside the mec where ONLY TWO adat cards
> are installed without any other in out cards.
> I don't know if I would take out my input cards if that woukld be solved
> but really cannot take that trouble right now !
> I thought in the beginning that one of my adat cards were faulty but three
> with same 5,6 SEND ONLY adat ports not working ?? nehh
> Well the ADAT INS work !! , I mean the 5,5 adat inputs work.
> So the problem is you cannot closse the adat loop for insert purpose on
> tracks
> 5 and 6.
> I even changed the eds card as EDNA suggested but same results so this has
> eliminated the EDS card problem.
> Well I don't know if I have 3 out of 4 eds cards malfunctioning ...
> I would like someone from you if he could thest somehow the above
> scenario.
> I would appreciatte.
> Regards,
> Dimitrios
|
|
|
|
The PARIS Forums
Search
Help
Members
Register
Login
Home
