Home » The PARIS Forums » PARIS: Main » Simple Cubase question
|
Re: Simple Cubase question [message #101119 is a reply to message #101116] |
Sun, 16 November 2008 17:00 |
John [1]
Messages: 2229 Registered: September 2005
|
Senior Member |
|
|
page 83
The Reset function
The Reset function on the MIDI menu sends out note-off
messages and resets controllers on all MIDI channels.
This is sometimes necessary if you experience hanging
notes, constant vibrato, etc.
� Cubase can also automatically perform a MIDI reset on
stop.
You can turn this function on or off in the Preferences (MIDI page).
� Also in the Preferences (MIDI page), you can find the
option �Insert Reset Events after Record�.
This is a very handy function for MIDI recording. At the end of each recorded
part, a Reset event will be inserted, resetting controller data such
as Sustain, Aftertouch, Pitchbend, Modulation, Breath Control, etc. This
is useful if a MIDI part is recorded and e.g. the Sustain pedal is still
held
after stopping recording. Usually, this would cause all following parts to
be played with Sustain, as the Pedal Off command was not recorded.
This can be prevented by activating �Insert Reset Events after Record�.
|
|
|
Re: Simple Cubase question [message #101126 is a reply to message #101119] |
Sun, 16 November 2008 20:25 |
Tom Bruhl
Messages: 1368 Registered: June 2007
|
Senior Member |
|
|
John,
Sounds like what I need. I'll give it a try.
Thanks!
Tom
"John" <no@no.com> wrote in message news:4920b429$1@linux...
>
> page 83
>
> The Reset function
> The Reset function on the MIDI menu sends out note-off
> messages and resets controllers on all MIDI channels.
> This is sometimes necessary if you experience hanging
> notes, constant vibrato, etc.
> . Cubase can also automatically perform a MIDI reset on
> stop.
> You can turn this function on or off in the Preferences (MIDI page).
> . Also in the Preferences (MIDI page), you can find the
> option "Insert Reset Events after Record".
> This is a very handy function for MIDI recording. At the end of each
> recorded
> part, a Reset event will be inserted, resetting controller data such
> as Sustain, Aftertouch, Pitchbend, Modulation, Breath Control, etc. This
> is useful if a MIDI part is recorded and e.g. the Sustain pedal is still
> held
> after stopping recording. Usually, this would cause all following parts to
> be played with Sustain, as the Pedal Off command was not recorded.
> This can be prevented by activating "Insert Reset Events after Record".
|
|
|
Goto Forum:
Current Time: Mon Dec 23 15:47:38 PST 2024
Total time taken to generate the page: 0.00938 seconds
|