Re: In the meantime: PARIS to REAPER via OMF [message #102845 is a reply to message #102844] |
Mon, 16 March 2009 23:07 |
Aaron Allen
Messages: 1988 Registered: May 2008
|
Senior Member |
|
|
Well TC, my understanding is that Mike rewrote enough of the EDS driver to
insert a layer connection and tap the EDS card on a much better level.
Details, I'm not sure on and I'd wait for him to elaborate on that
anyway..... it's dude's project :)
However, if I understand that all correctly it's big. Very big.
> I guess I'm wondering to what degree this could be possible, and if this
> would make it (Reaper/w Paris hw) fall somewhere between a dedicated dsp
> system (Paris/PT), and a fully Native system?
Personally, what I'm hoping for is a creamware type situation w/o the
hard-to-use SCOPE software. Disk streams, mix control, VSTi and GUI all
comes off the app, but the actual summing and Paris EQ's/EDS FX/latency and
I/O control DSP is slamming it on the PCI cards. With the Reaper
architecture, I could even see someone writing controls to use the Cs16's.
Perfect world man!
AA
[Updated on: Fri, 20 March 2009 11:24] by Moderator Report message to a moderator
|
|
|