The PARIS Forums


Home » The PARIS Forums » PARIS: Main » A question about building EDS cables
A question about building EDS cables [message #68449] Sun, 21 May 2006 09:18 Go to previous message
Deej [1] is currently offline  Deej [1]   UNITED STATES
Messages: 2149
Registered: January 2006
Senior Member
It appears that these are really just abbreviated ATA 33 cables. I've got a
bunch of these here. So I could just get a chainsaw and cut the width down
to the same number of rows of conductors of an EDS cable, I
assume.......but, the IDE cables have two connectors, on one end. Can I just
use the length of cable between any two of the connectors or do I need to
use the long cable run between the mobo conductor and the first drive
connector. If I can use the stretch of cable between any two connectors,
then I'm assuming it's OK to trim the remaining cable that is trailing after
the conductor.......maybe using a shaped charge to do this?

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Read this: From Russia, With Dread
Next Topic: SM57, how long to warm up?
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Apr 23 15:05:59 PDT 2025

Total time taken to generate the page: 0.01459 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software