The PARIS Forums


Home » The PARIS Forums » PARIS: Main » Another little project (The MECGyver)
icon7.gif  Another little project [message #106307] Fri, 22 April 2011 19:11 Go to previous message
Jim Drago[2] is currently offline  Jim Drago[2]   
Messages: 102
Registered: December 2008
Senior Member
I needed a mental challenge to help deal with some personal issues and have been needing to save some room so decided to combine one of my MEC's and it's computer. Here's where I'm at. My CPU came today (AMD Phenom II x2 @ 3.2) and I should have RAM soon and then can finish up. No permanent mods to MEC it can be reconfigured to completely stock in 20 or so minutes. PS DVD and HD mounted to inner roof. Gigabyte MB to floor n a modified chassis from another computer. This configuration will give me 2 PCI slots for EDS cards and leave room for 2 MEC modules. Hope it all works. Because of the length of our beloved EDS cards I had to extend and box in part of the back of the MEC. More pics after I finish later next week. The keyboard project I built has ADAT out and with an ADAT MEC module it should be sweet. Here's the thread on that build. Let me know if the more experienced among you foresee any possible pitfalls.

http://kerrygalloway.com/ParisForums/index.php?t=msg&th= 15086&start=0&


index.php?t=getfile&id=764&private=0 Very Happy Very Happy
  • Attachment: MecGyver.jpg
    (Size: 804.52KB, Downloaded 652 times)

[Updated on: Fri, 22 April 2011 19:28]

Report message to a moderator

[Message index]
 
Read Message icon7.gif
Read Message
Read Message
Read Message
Previous Topic: Conversion from Pro Tools to Paris
Next Topic: Setting up a 2 Mec system
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun May 25 20:47:24 PDT 2025

Total time taken to generate the page: 0.03857 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software